A-wind B-wind

From PD Research Wiki
Jump to navigation Jump to search

Everything about A-wind B-wind

A-wind and B-wind confused me for years. The simplest way I have found to understand them is this:

A-wind and B-wind are not properties of the film stock itself. They describe the winding of a roll of single-perforated film.

Imagine taking a strip of 16 mm film and laying it loose in a box, or stretching it out in one very long straight line.

In that state, it is not really useful to call it A-wind or B-wind. Once that strip is wound onto a core or reel, however, its orientation can be described as A-wind or B-wind.


For example, 16 mm camera negative is normally supplied as B-wind, while print stock intended for contact printing is normally supplied as A-wind.

This does not mean that B-wind makes a film into negative stock, or that A-wind makes it print stock.

These are simply the windings normally required by the equipment and process.

You could take a piece of print stock and wind it B-wind.

It would then physically be a B-wind roll, but it would still be print stock.


Likewise, if a large roll of print stock is supplied A-wind and you rewind some of it onto another reel or spool in the conventional way, that smaller roll can become B-wind.

Rewind it once more and it can become A-wind again.


One more important detail: this terminology is primarily meaningful for single-perforated film.

With double-perforated 16 mm film, there are perforations on both edges, so the A-versus-B distinction based on which perforated edge faces the observer no longer works in the same way.

For example, in my DIY camera, I originally designed the film transport with the same perforation orientation as a Bolex. Later, while trying to improve image stability, I reversed the orientation of the perforation drive.

As a result, the exposed film is taken up in the opposite winding orientation from the conventional 16 mm camera arrangement. Instead of producing the usual B-wind camera original, my camera takes up the exposed film as A-wind.

If I then make a conventional contact print from that A-wind original, the resulting print will have the opposite orientation and become B-wind.

It was confusing, because most of my film is very abstract, so if I flip the image upside down and play it from the end to beginning, it changes the winds... and hard to notice.

A-wind / B-wind describes how the film is wound/oriented on the roll

A useful rule of thumb for conventional 16 mm work is:

Camera negative → usually B-wind Contact-print stock → usually A-wind


Camera negative stock supplied B-wind → load normally.

Print stock supplied A-wind → rewind it to B-wind before shooting it in the Bolex.

but you rewind the film from one reel onto another, you reverse the winding.


Wind-b.png Wind-a.png


What happened with the experimental Camera

Most of my images are abstract, and sometimes difficult to identify the wind type.


on editing table

On the editing table, loading normally and playing forward.

When the emulsion is facing outwards, it is B-wind

When the emulsion is facing inwards, it is A-wind.

camera neg on editing table

Cam-neg-wind-01.jpg Cam-neg-wind-02.jpg

Cam-neg-wind-03.jpg Cam-neg-wind-04.png

DIY Camera

Sometimes I have to film upside down or backwards.